|
OPTIONAL CHARGE CONTROLLERS
|
|
 |
NC25A
|
|
The NC25A is a series regulator designed for alternative energy charging systems ranging in size from 0.1A to 25A. It is the ideal regulator for solar and permanent magnet generators.
The NC25A includes the charge divert feature, which allows you to use the excess charging source energy for other tasks, or for placing a load on the Windbugger to prevent over speed conditions. The divert connection is only activated after the charging source is making energy and the batteries are not using the energy.
This controller can be expanded to handle one or more banks of 100A charging sources. Multiple battery banks can be charged with the use of a standard battery charging isolator.
The NC25 is designed for long-term unattended operation, extensive transient voltage protection, high steady-state voltage protection, reverse polarity protection on battery connections, fully sealed electronics for 100% humidity operation. It is designed for "install and forget" operation.
|
|
|
 |
Models PV7, PV7D
|
|
The PV7 (single battery bank) and PV7D (dual battery banks) are cost effective shunting regulators designed for smaller 12V solar only applications with a maximum solar charging current of 7A.
All shunting type regulators must use a blocking diode in the charging path to block the battery voltage when the controller is regulating.
No heat sink is required because of the small amount of heat that is generated in the high efficiency solid state components.
Use with lead acid or gel battery technologies.
Price $70
|
|
|
 |
Model PV14
|
|
The PV14 is a cost effective shunting regulator designed for smaller 12V solar only applications with a maximum solar charging current of 14V.
All shunting type regulators must use a blocking diode in the charging path to block the battery voltage when the controller is regulating.
The heat sink is used to dissipate heat generated by the high efficiency blocking diode.
|
|
|
|
